NordicTrack NTL09707.7 - Page 7

7
2. Identify the Left Upright (73) and the Right
Upright (74).
H
old the Right Upright (74) near the Right Base
Cover (77). See the inset drawing. Locate the
w
ire tie in the rectangular hole in the lower end
of the Right Upright. Tie the wire tie securely
around the end of the Upright Wire (75). Pull the
other end of the wire tie up through Right Upright
until the Upright Wire is routed completely
through the Right Upright.
Gently pull up on the Upright Wire (75) as you
set the Right Upright (74) on the Base (83) in-
side the Right Base Cover (77). Be careful not
to pinch the Upright Wire.
Attach the Right Upright (74) to the Base (83)
with two Upright Bolts (72) and two Upright Star
Washers (90). Do not tighten the Upright
Bolts yet. Note: It may be necessary to tip the
upper end of the Right Upright forward slightly
as you thread the Upright Bolts into it.
Attach the Left Upright (73) to the Base (83) with
two Upright Bolts and two Upright Star Washers
(not shown). Do not tighten the Upright Bolts
yet.
With the help of a second person, lower the
treadmill off the cardboard stand.
83
75
T
ie
77
2
74
73
90
72
3. Identify the Right Upright Sleeve (96) and the
Left Upright Sleeve (95); the Upright Sleeves are
labeled. Slide the Right Upright Sleeve onto the
Right Upright (74), and slide the Left Upright
Sleeve onto the Left Upright (73).
95
“Right”
“Left”
96
3
74
73
75
74
Tie