NordicTrack NTL09707.7 - Page 8

8
4. With the help of a second person, hold the con-
sole assembly near the Uprights (73, 74).
C
onnect the Upright Wire (75) to the Console
Wire Harness (71). See the inset drawing. The
c
onnectors should slide together easily and
snap into place. If they do not, turn one con-
nector and try again. IF THE CONNECTORS
ARE NOT CONNECTED PROPERLY, THE
CONSOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON.
Remove the tie from the Upright Wire (75).
71
Console
Assembly
4
75
Tie
74
5. Insert the brackets on the Handrails (99) into the
Uprights (73, 74). Make sure that no wires are
pinched.
73
5
74
99
6. Finger tighten three Handrail Bolts (64) with
three Upright Star Washers (90) into the Right
Upright (74). Next, finger tighten three Handrail
Bolts with three Star Washers (not shown) into
the Left Upright (73). Then, firmly tighten the six
Handrail Bolts.
73
74
64
64
90
90
75
6
7
3
99
71