13
10
10. Rotate the console assembly (E) back to
its original position. Firmly tighten the two
M6 x 25mm Screws (8) that you attached in
step 8.
Next, identify the Right Pivot Cover (137). Attach
the Right Pivot Cover to the Console Pivot
Bracket (138) with an M4 x 20mm Screw (6); do
not overtighten the Screw.
8
6
138
137
E
11. Rotate the console assembly (E) to the position
shown.
Next, identify the Left and Right Trays (141, 142).
Orient the Left Tray (141) as shown. Next, peel
the backing (A) off the adhesive pad on the Left
Tray. Then, press the Left Tray onto the handrail
assembly (D) until it snaps into place (see the
inset drawing).
Attach the Right Tray (142) in the same way.
11
142
D
141
E
141
A
To Next Page
Loading...
