36
b. If the walking belt slips when walked on, fi rst
remove the key and UNPLUG THE POWER
CORD. Using the hex key, turn both idler roller
screws clockwise 1/4 of a turn. When the walking
belt is correctly tightened, you should be able to
lift each edge of the walking belt 2 to 3 in. (5 to 7
cm) off the walking platform. Be careful to keep
the walking belt centered. Then, plug in the power
cord, insert the key, and walk on the treadmill for a
few minutes. Repeat until the walking belt is prop-
erly tightened.
SYMPTOM: The console does not stay in place
a. If the console does not stay in the desired position
because it is too loose, use a hex key to slightly
tighten the console in the indicated location on both
sides (only one side is shown).
b
a
To Next Page
Loading...
