NordicTrack NTL99011.3 - Treadmill Assembly - Final Cover and Screw Tightening; Tightening Console Assembly Screws; Installing Handrail Covers

14
15. Tighten nine #8 x 3/4" Screws (2) into the
Console Base Back (93) in the indicated loca-
tions; start with the center Screw.
Note: Some of the #8 x 3/4” Screws (2) are
designed to go in at different angles.
2
15
2
2
2
2
2
2
93
Start First
16. Slide the Handrail Covers (79, 80) forward until
they match up with the Console Base (64).
Attach the Handrail Covers with the four #8 x
1 1/4" Screws (107) that you removed in steps 9
and 10. Do not overtighten the Screws.
Tighten four #8 x 3/4" Screws (2) into the con-
sole assembly in the locations shown.
Note: Some of the #8 x 3/4” Screws (2) are
designed to go in at different angles.
Raise the Base Covers (82, 83) and firmly
tighten the four 3/8" x 2 3/4" Screws (7) first and
then the 3/8" x 1 1/4" Screws (8) (only one side
is shown). Then, press the Base Covers into
place.
16
Console
Assembly
107
107
82
83
8
2
2
80
79
64
7