NordicTrack RW700 - Page 10

10
6. With the help of a second person, tip the rower
to the upright position.
Remove and discard the two shipping screws (B)
and the shipping bracket (A).
7. Tip: Avoid pinching the wires. Hold the
Neck (8) with the attached Console (6) inside
the bracket on the Frame (1). Attach the Neck
with an M10 x 40mm Screw (105); do not fully
tighten the Screw yet.
Finish attaching the Neck (8) with an
M10 x 65mm Screw (119). Then, fully tighten
the M10 x 40mm Screw (105).
Then, connect the Neck Wire (93) to the Main
Wire (92). Tip: The wire connectors should
slide together easily and snap into place
with an audible click. If they do not, turn one
connector and try again.
6
7
B
B
6
8
92
93
A
1
105
119
Avoid pinching
the wires