NordicTrack S27i - Page 7

7
2
2. See the inset drawing. Orient the Handlebar
Post (7) so that the lower slot (A) is on the side
shown.
Next, loosen the indicated Post Knob (100) and
insert the Handlebar Post (7) all the way into the
Frame (1). Make sure that the indicated slots
(B) are aligned. Then, tighten the Post Knob.
Then, insert the end of the Lower Wire (122) into
the Frame (1) and the Handlebar Post (7), and
pull it out of the upper slot (C) in the Handlebar
Post as shown by the dashed line at the right.
100
100
7
A
C
D
B
1
7
7
1
3
3. IMPORTANT: To prevent the Lift Cylinder (not
shown) inside the Handlebar Post (7) from
moving, make sure that the Post Knob (100)
is firmly tightened.
See the inset drawing. Loosen the indicated
shipping screw (D) a quarter of a turn. You
should now be able to turn the shipping screw
easily with your fingers. If the shipping screw
does not turn easily, tighten the Post Knob
(100) again. Then, remove and discard the
shipping screw.
Then, insert the Handlebar (97) into the
Handlebar Post (7). Attach the Handlebar with
four M8 x 12mm Patch Screws (93); start all the
Patch Screws, and then tighten them.
97
7
93
93
122
100