17
4. Change the incline of the treadmill as desired.
To change the incline of the treadmill, press the
Incline/Decline increase or decrease button or one
of the numbered 1 Step Incline/Decline buttons.
Each time you press one of the buttons, the tread-
mill will gradually adjust to the selected incline
setting.
5. Follow your progress with the displays.
As you walk or run on the treadmill, the display can
show the following workout information:
•Theelapsedtime
•Thedistancethatyouhavewalkedorrun
•Theworkoutintensitybar
•Theapproximatenumberofcaloriesyouhave
burned
•Theinclinelevelofthetreadmill
•Thenumberofverticalfeetyouhaveclimbed
•Thespeedofthewalkingbelt
•Yourheartrate(seestep6onpage18)
•Thematrix
The matrix offers several display tabs. Press the
increase and decrease button next to the Enter
button until the desired tab is shown.
The Incline tab will show a profile of the incline set-
tings of the workout. A new segment will appear at
the end of each minute. The Speed tab will show a
profile of the speed settings of the workout.
The My Trail tab will show a track that represents
400 m (1/4 mile). As you exercise, the flashing
rectangle will show your progress. The My Trail tab
will also show the number of laps you complete.
The Calorie tab will show the approximate amount
of calories you have burned. The height of each
segment represents the amount of calories burned
during that segment.
As you exercise, the workout intensity level bar will
indicate the approximate intensity level of your
exercise.
Press the Home button to return to the default
menu (see THE INFORMATION MODE on page
22 to set the default menu). If necessary, press the
Home button again.
When a wireless iFit Live
module is connected, the
wireless symbol at the top
of the display will show the
strength of your wireless
signal. Four arcs indicate full
signal strength.
To reset the displays, press the Stop button,
remove the key, and then reinsert the key.
ETS129710
(24992, NTL11010)
To Next Page
Loading...
