NordicTrack T7 Ze Treadmill - Page 8

8
6. Set the Left Upright Spacer (76) on the Base
(83). With the help of a second person, hold a
Bolt Spacer (90) inside the lower end of the Left
Upright (74). Insert a 3/8" x 5" Bolt (6) with a
3/8" Star Washer (9) into the Left Upright and
the Bolt Spacer. Repeat this step with a sec-
ond Bolt Spacer (90), 3/8" x 5" Bolt (6), and
3/8" Star Washer (9). Set the Left Upright into
the Left Upright Spacer.
Partially tighten the 3/8" x 5" Bolts (6); do not
fully tighten the Bolts yet.
Press a Base Endcap (77) into the Base (83).
With the help of a second person, tip the tread-
mill so that the Base (83) is flat on the floor.
76
74
6
83
77
90
6
5. With the help of a second person, carefully tip
the treadmill onto its right side. Partially fold the
Frame (56) so that the treadmill is more stable;
do not fully fold the Frame yet.
Remove and discard the two indicated bolts (A)
and the shipping bracket (B).
Attach a Base Pad (81) to the Base (83) in the
location shown with a #8 x 1" Tek Screw (2) and
a Base Pad Spacer (13). Then, attach another
Base Pad (81) with only a #8 x 1" Tek Screw (2).
Remove the 3/8" Nut (8), the 3/8" x 2" Bolt (4),
and the shipping bracket (C) from the Base (83).
Attach a Wheel (84) with the Bolt and the Nut
that you just removed. Do not overtighten the
Nut; the Wheel must turn freely. Discard the
shipping bracket.
5
83
B
A
84
56
4
8
C
81
2
81
13
2
4. With the help of a second person, hold a Bolt
Spacer (90) inside the lower end of the Right
Upright (78). Insert a 3/8" x 5" Bolt (6) with a
3/8" Star Washer (9) into the Right Upright and
t
he Bolt Spacer. Repeat this step with a sec-
ond Bolt Spacer (90), 3/8" x 5" Bolt (6), and
3/8" Star Washer (9). Set the Right Upright into
the Right Upright Spacer (79).
Partially tighten the 3/8" x 5" Bolts (6); do not
fully tighten the Bolts yet.
Press a Base Endcap (77) into the Base (83).
79
78
77
6
4
83
38
9
90
9