25
SYMPTOM: The walking belt is off-center or slips
when walked on
a
. If the walking belt is off-center, first remove the
key and UNPLUG THE POWER CORD. If the
w
alking belt has shifted to the left, use the hex
key to turn the left idler roller screw clockwise 1/2
of a turn; if the walking belt has shifted to the
right, turn the left idler roller screw counterclock-
wise 1/2 of a turn. Be careful not to overtighten the
walking belt. Then, plug in the power cord, insert
the key, and run the treadmill for a few minutes.
Repeat until the walking belt is centered.
b. If the walking belt slips when walked on, first re-
move the key and UNPLUG THE POWER CORD.
Using the hex key, turn both idler roller screws
c
lockwise, 1/4 of a turn. When the walking belt is
correctly tightened, you should be able to lift each
e
dge of the walking belt 2 to 3 in. (5 to 7 cm) off
the walking platform. Be careful to keep the walk-
ing belt centered. Then, plug in the power cord, in-
sert the key, and carefully walk on the treadmill for
a few minutes. Repeat until the walking belt is
properly tightened.
SYMPTOM: The console display has lines running
through it
a. If lines appear in the console display, see THE IN-
FORMATION MODE on page 21 and adjust the
contrast level of the display.
a
b
To Next Page
Loading...
