NordicTrack T8.0 Treadmill - Page 7

7
3. Identify the Left Upright (75), which is either
marked “Left” or “L.” Have a second person hold
the Left Upright near the Base (80).
See the inset drawing. Tie the wire tie in the
Left Upright (75) securely around the end of the
Upright Wire (70). Then, pull the other end of the
wire tie until the Upright Wire is routed through
the Left Upright.
3
1
. Make sure that the power cord is unplugged.
A
ttach a Wheel (81) to the Base (80) with a 3/8"
x 2 1/2" Bolt (2) and a 3/8" Nut (3). Do not over-
tighten the Nut; the Wheel must turn freely.
A
ttach the other Wheel (not shown) to the
other side of the Base (80) in the same way.
1
81
80
2
3
70
75
75
Wire
Tie
70
Wire Tie
2. Remove the ties securing the Upright Wire (70)
to the Base (80). Pull the Upright Wire and the
Base Ground Wire (92) through the indicated
hole in the Base.
Attach the Base Ground Wire (92) to the Base
(80) with a #8 x 1/2" Ground Screw (1).
Press a Base Cap (77) into each side of the
Base (80). Press the Grommet (67) into the
square hole in the Base.
70
2
Hole
1
92
77
80
67
80