NordicTrack T9si - Page 8

8
7. Press a Base Cap (88) into the Base (95).
Set the Left Upright Spacer (87) on the Base
(95). Have a second person hold the Left
Upright (85) near the Base. Hold a Bolt Spacer
(25) inside the lower end of the Left Upright.
Insert a 3/8" x 4" Bolt (6) with a 3/8" Star
Washer (10) into the Left Upright and the Bolt
Spacer. Repeat this step with a second Bolt
Spacer (25), 3/8" x 4" Bolt (6), and 3/8" Star
Washer (10). Then, set the Left Upright into the
Left Upright Spacer.
Finger tighten the 3/8" x 4" Bolts (6); do not
fully tighten the Bolts yet.
With the help of a second person, tip the tread-
mill so that the Base (95) is flat on the floor.
87
85
6
95
88
25
7
6. With the help of a second person, carefully tip
the treadmill onto its right side. Partially fold the
Frame (57) so the treadmill is more stable; do
not fully fold the Frame yet.
Remove and discard the two indicated bolts (A)
and the shipping bracket (B).
Attach a Base Foot (93) to the Base (95) in the
location shown with a #8 x 1" Tek Screw (4) and
a Base Foot Spacer (11). Then, attach another
Base Foot (93) with only a #8 x 1" Tek Screw (4).
Attach a Wheel (96) with the 3/8" Nut (9) and
the 3/8" x 2" Bolt (5) that you removed in step 1.
Do not overtighten the Nut; the Wheel must
turn freely.
6
95
57
5
9
93
4
93
96
11
4
5. Press a Base Cap (88) into the Base (95).
Hold a Bolt Spacer (25) inside the lower end of
the Right Upright (86). Insert a 3/8" x 4" Bolt (6)
w
ith a 3/8" Star Washer (10) into the Right
Upright and the Bolt Spacer. Repeat this step
with a second Bolt Spacer (25), 3/8" x 4" Bolt
(6), and 3/8" Star Washer (10). Then, set the
R
ight Upright into the Right Upright Spacer (92).
Partially tighten the 3/8" x 4" Bolts (6); do not
fully tighten the Bolts yet.
92
86
88
6
5
95
97
10
10
2
5
25
A
B