NordicTrack T9si - Console and Handrail Assembly

9
8. Set the console assembly face down on a soft
surface to avoid scratching the console assem-
bly. Identify the Right Handrail (105), which is
m
arked with a sticker. Hold the Right Handrail
near the console assembly.
Next, insert the console wire through the indi-
cated holes in the Right Handrail (105) as
shown.
8
1
05
C
onsole Wire
Holes
C
onsole
Assembly
9. Attach the Left Handrail (101) and the Right
Handrail (105) to the console assembly with four
#8 x 1/2" Screws (2), two 3/8" x 3/4" Patch Bolts
(8), and two 3/8" Star Washers (10). Do not
fully tighten the Screws or Patch Bolts yet.
9
2
10
8
101
Console
Assembly
2
8
10
105
10. Press the Left Handrail Cover (100) against the
console assembly. See the inset drawing.
Align the lip on the Left Handrail Cover with the
lip on the console assembly. Then, fully tighten
the four #8 x 1/2" Screws (2) in the Left Handrail
(101). Note: The Screws are preattached.
Repeat this step with the Right Handrail
Cover (107).
Tighten two 1/4" x 1/2" Bolts (3) into the
Handrails (101, 105) and the console assembly.
See step 9. Fully tighten the four #8 x 1/2"
Screws (2) and the two 3/8" x 3/4" Patch Bolts
(8).
10
Console
Assembly
3
3
100
107
2
2
2
2
Lips
101
105