NordicTrack VR25 - Maintenance and Troubleshooting; Regular Product Maintenance; Console Troubleshooting Guide; Adjusting the Reed Switch

28
MAINTENANCE
Regular maintenance is important for optimal
performance and to reduce wear. Inspect and properly
tighten all parts each time the exercise bike is used.
Replace any worn parts immediately.
To clean the exercise bike, use a damp cloth and a
small amount of mild soap. IMPORTANT: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
CONSOLE TROUBLESHOOTING
If the console does not turn on, make sure that the
power adapter is fully plugged in.
If the console does not display your heart rate when
you use the handgrip heart rate monitor, see step 5 on
page 20.
If the console does not display your heart rate
when you use the chest heart rate monitor, see
TROUBLESHOOTING on page 15.
If you are having problems connecting the console
to a wireless network or if you are having problems
with your iFit account or iFit workouts, go to
support.iFit.com.
If a replacement power adapter is needed, call the
telephone number on the cover of this manual.
IMPORTANT: To avoid damaging the console, use
only a manufacturer-supplied regulated power
adapter.
TABLET HOLDER TROUBLESHOOTING
If the tablet holder does
not stay in place, rotate
the tablet holder backward
and tighten the screw (A)
until the tablet holder stays
in place when it is rotated
to the desired position.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted.
To adjust the reed switch, first unplug the power
adapter.
See EXPLODED DRAWING A on page 34. Using
a standard screwdriver, gently release the tabs on the
Top Shield (44). Slide the Top Shield upward.
Next, remove the M4 x 16mm Screw (77) from the
Access Cover (40). Then, remove the Access Cover.
Locate the Reed Switch (46). Turn the Left Crank Arm
(24) until a Pulley Magnet (30) is aligned with the Reed
Switch. Slightly loosen the indicated M4 x 16mm Screw
(77). Slide the Reed Switch slightly closer to or away
from the Pulley Magnet, and then retighten the Screw.
Plug in the power adapter, and turn the Left Crank
Arm (24) for a moment. Repeat these actions until the
console displays correct feedback.
When the reed switch is correctly adjusted, unplug
the power adapter and reattach the parts that you
removed. Then, plug in the power adapter.
A
24
30
77
46
MAINTENANCE AND TROUBLESHOOTING