11
4. Set the Uprights (83) on the Base (74). Make
sure that the hole with the Upright Wire (75)
is on the right side.
Attach the right Upright (83) to the Base (74)
with four of the 3/8" x 2 3/4" Screws (22) that you
removed and four 3/8" Star Washers (3). Make
sure that the Base Wire (52) is not pinched.
Do not tighten the Screws yet.
Attach the left Upright (not shown) in the
same way. Note: There is not a wire on the left
side.
Fully tighten all eight 3/8" x 2 3/4" Screws
(22).
3. Remove the four 3/8" x 2 3/4" Screws (22)
from the Uprights (83). Save the Screws.
3
83
22
22
4
22
3
3
52
74
75
22
83
3
3
To Next Page
Loading...
