10
8
8. Press the two tabs on the Tablet Holder (65) into
the slots (G) in the console assembly (D).
Attach the Tablet Holder (65) with four #8 x 5/8"
Machine Screws (8). Tip: Start the two top
Machine Screws rst, and then start the two
bottom Machine Screws. Be careful not to
overtighten the Machine Screws.
IMPORTANT: The Tablet Holder (65) is
designed for use with most full-size tablets.
Do not place any other electronic device or
object in the Tablet Holder.
65
Start First
D
G
8
77
9. If necessary, move the incline trainer to the
desired location (see HOW TO MOVE THE
INCLINE TRAINER on page 20).
After the incline trainer is placed in the loca-
tion where it will be used, make sure that the
incline trainer rests firmly on the floor. If the
incline trainer rocks even slightly, turn a Leveling
Foot (77) as needed until the rocking motion is
eliminated.
9
10. Make sure that all parts are properly tightened before you use the incline trainer. To protect the floor or
carpet from damage, place a mat under the incline trainer. To avoid damage to the console, keep the incline
trainer out of direct sunlight. Note: Keep the included hex keys in a secure place. One of the hex keys is used
to adjust the walking belt (see pages 22 and 23).
To Next Page
Loading...
