NordicTrack X7i - Page 9

9
6
1
2
D
E
6. Identify the right handrail assembly (C). Hold
the right handrail assembly near the right side of
the console assembly (D), and connect the two
pulse wires (E).
Next, set the right handrail assembly (C) on the
console assembly (D). Make sure that no wires
are pinched.
Attach the right handrail assembly (C) with a
3/8" x 5 1/2" Screw (1) and a 3/8" x 3 3/4" Screw
(2); start both Screws, and then tighten them.
Attach the left handrail assembly (not shown)
as described above.
C
7. Slide the Right Inside Upright Cover (70) against
the lower end of the right Upright (83). Then,
press the Right Outside Upright Cover (71)
against the Right Inside Upright Cover until it
snaps into place. Make sure that the wires (F)
are not pinched.
Attach the Left Inside Upright Cover (not
shown) and the Left Outside Upright Cover
(not shown) as described above. Note: There
is not a wire on the left side.
70
71
83
F
7