NordicTrack X9i incline trainer NTL19010.0 - Page 10

10
7. Set the right handrail assembly (B) onto the
right Upright (77). Make sure that no wires are
pinched. Attach the right handrail assembly
with two 3/8" x 5 1/2" Screws (5) and two 3/8"
Star Washers (8). Note: Start the lower Screw
first.
Connect the two “R” pulse wires.
L
R
R
7
5
“L” Pulse
Wire
Start First
B
77
8
Console
Assembly
6. Tighten two #8 x 3/4" Screws (1) into the
Console Base (87). Do not overtighten the
Screws.
Identify the right handrail assembly (B). Hold the
right handrail assembly near the right Upright
(77). Insert the wire from the right handrail as-
sembly into the hole in the top of the Upright
and out of the end of the Upright.
6
B
Wire
1
1
87
77
“R”
Pulse
Wires