Nordson AD-31 Series - Page 29

lnstallation
3-3
Handgun
to
Hose Connection
(contd.)
4203011
Fig.3-3 Attaching the Hose to the
Handgun
(electical
connections
not
shown
for
clarity)
420307s
Fig. 3-4 Secuing the
Wires with
the
Retaining Clip
4.
Attach
the
hose fitting to the swivel
connector,
and tighten using two
wrenches. Place
a
20-mm
(3/4-in.lwrench
on the
wing
of the swivel
connector, and
tighten
the hose fitting using the 18-mm
(11/re-in.)
wrench.
WARNING: An electric short can occur if
wires do not lie flat
and side by side, not crossing each other within the
groove.
5.
Rotate
the
wire retaining clip
around
the
pivot
sleeve so that the clip's
opening aligns with one of the
grooves
on the
pivot
sleeve.
6.
Place one set of wires into the
groove
and rotate the
wire
retaining
clip
so that
it holds
the
wires
securely
in the
groove.
lf
your
handgun
uses configurations A or
B,
repeat steps 5 and
6
to
secure the other
set of wires. To determine
your
handgun's configuration,
refer to
Electrical Connections.
@
1995 Nordson Corporation
All rights reserued
42-72
lssued 10/95
A3EN-04-[AD-31 EXJ-I