3-10
lnstallation
1
2
N
o
s
o
4203015
Fig.3-14
Connecting the Heater
Fig. 3-15 Connecting the Electrical
Switch
(if
applicable)
Connecting the Heater
6. On the heater side of the
pivot
sleeve, loosen the two screws on the
heater terminal block as shown in Figure 3-14. lnsert wires 1 and 2,
extending from
the
hose, into the terminal block.
7. Tighten
the two terminal-block screws to
O.42 N.m
(3.7
lbf-in.),
taking
care
not
to overtighten.
CAUTION: When replacing the
pivot-sleeve
shells, do not
pinch
wires between the shells and the
pivot
sleeve.
An
electrical short can occur if wires are
pinched.
8. Replace the
pivot
sleeve shells and secure
with
screws
Electrical
Switch Connections
(if
applicable)
9. lf
your
handgun has an electrical switch
follow steps a and b
to
connect the electrical switch:
a. Find the orientation lug on the hose-cordset connector and ensure
that the connector and switch
plug
at the bottom of the handgun's
handle are
properly
aligned.
b. Attach the switch
plug
assembly at the bottom of the
handle
to the
connector on
the
hose cordset.
10.
Follow the hose installation
instructions in
your
applicator
product
manual to connect the hose to
the
applicator.
t
4203051
A3EN-0'I-[AD-31Exl-1
42-72
lssued 10/95
@
1995 Nordson
Corporation
All
rights reserued
To Next Page
Loading...
