Parts
9-3
Part 1120130
E 2011 Nordson Corporation
DescriptionOptionsCodeItemBox
14 Flow control
A Pneumatic PCV Pneumatic PCVs are installed, allowing the
bypass pressure to be adjusted using a
customer‐supplied air pressure regulator.
V Circulation control valve Circulation control valves are installed,
allowing recirculated adhesive to be
controlled when a single adhesive stream
is split between multiple applications in
which the adhesive flow to each
application needs to be balanced because
of differing add‐on rates.
M Manual Pneumatic Pressure
Control
Pneumatic PCVs with air regulators are
installed, allowing the operator to change
the system pressure by adjusting the
regulators.
F Flow Control Bypass Pneumatic PCVs with corresponding air
regulators and controlling solenoids are
installed, by customer supplied signals
triggering the solenoids to switch the
hydraulic system between pneumatic
pressure control mode (by manually
adjustable air pressure regulators) and the
volumetric mode (which means that no
material circulates through the pneumatic
pressure control valve).
X Manual PCV Standard manual PCVs are installed,
allowing the manual adjustment of
adhesive pressure.
15 Reserved X — —
16 Low‐level
indication
L Low‐level indication present The low‐level indication provides a signal
when the level of adhesive in the tank falls
below a specified value.
X None No low‐level indication
17 I/O and
indication
X None No optional I/O expansion card
18 LCD Cover
C LCD cover LCD cover is installed
X None —
19 Host
communication
X None No communication card
20 Return port
R 1 hose return port One hose return port is installed.
X None No hose return port
21 Motion switch X None No motion switch
22 Sensor type
N 120‐ohm nickel sensors Requires Nordson T‐style hose/applicator
connectors
P 100‐ohm platinum sensors Requires Nordson M‐style hose/applicator
connectors
23-25 Reserved X — —
To Next Page
Loading...
