Introduction
2-6
Part 1120130
E 2011 Nordson Corporation
Modes of Operation
AltaBlue melters operate in the following modes.
Heating and Heaters Off (Normal Mode)
The melter operates with the heaters either on or off. The melter will trigger a
“ready” condition when the heaters reach their programmed temperature
zones (hopper and reservoir) and external zones (hoses, standard and large
applicators and air heaters) confirming all zones are within their pre‐defined
setpoint temperature range.
Standby
All internal and external zones are reduced, by the default 50C (90F) down
from their setpoint temperature.
Fault
The melter alerts the operator when an abnormal event occurs.
Gear‐to‐Line Capability
The melter is capable of delivering an adhesive output that is geared to the
production line speed. A line‐speed signal generator must be installed if you
want to use the gear‐to‐line capability.
To Next Page
Loading...
