Nordson AltaBlue - Page 4

Table of Contents
ii
Part 1120130
E 2011 Nordson Corporation
Connecting Hoses and Applicators 3‐12............................
To connect hoses 3‐12......................................
To connect applicators 3‐18..................................
Connecting and Programing the Pump for Remote Control 3‐24........
Wiring 3‐24..................................................
Programming 3‐24............................................
Installing Optional Equipment 3‐26................................
Connecting a applicator Driver, Pattern Controller, or Timer 3‐26.......
Flushing the Melter 3‐26.........................................
Disposing of Melter 3‐26.........................................
About the Touch Screen Display and User Interface 4-1..........
Overview 4‐1..................................................
Starting the Melter for the First Time 4‐1........................
What's Next? 4‐1..........................................
Navigating the Touch Screen Displays 4‐2......................
About the Main Display 4‐2....................................
Accessing the Main Display 4‐2.............................
About the Monitor Display 4‐3.................................
Accessing the Monitor Display 4‐3...........................
What the Monitor Display Status Colors Indicate 4‐4...........
About the Operator Display 4‐5................................
State and Status Indicators from the Operator Display 4‐6.........
Zone and Pump State Color Indicators 4‐6....................
Zone and Pump Status Color Indicators 4‐6...................
Master Control Color Indicators 4‐7..........................
About the Settings Display 4‐7.................................
Accessing the Settings Display 4‐7..........................
About the System Primary Display 4‐9..........................
Accessing the System Display 4‐9...........................
Operating the Melter 5-1.......................................
Introduction 5‐1................................................
Starting the Melter 5‐1........................................
Filling the Reservoir 5‐2......................................
Operating Zones 5‐2.........................................
Operating Pumps 5‐4........................................
Adjusting Pump RPM in Manual Mode 5‐5....................
Adjusting Pump RPM in GeartoLine Mode 5‐6...............
Using the Master Controls 5‐6.................................
Performing Advanced System Operations 5‐8...................
Running a System Diagnostic 5‐8............................
Reverting back to Factory Settings 5‐8.......................
Resetting the Password 5‐8.................................
Configuring and Modifying Temperature, Pump and Melter Settings . .
6-1
Overview 6‐1..................................................
Manage Temperature Settings 6‐3.............................
Manage Pump Settings 6‐4...................................
Managing System Settings 6‐5................................