Repair
8-6
Part 1123087_02
3/2014 Nordson Corporation
Melter Repair Procedures
WARNING! Molten material! Wear eye or face protection, clothing that
protects exposed skin, and heat‐protective gloves when servicing equipment
that contains molten hot melt. Even when solidified, hot melt can still cause
burns. Failure to wear appropriate personal protective equipment can result
in personal injury.
WARNING! Risk of electrocution! Even when switched off and electrically
isolated at the disconnect switch or circuit breaker, the equipment may still
be connected to energized auxiliary devices. De‐energize and electrically
isolate all auxiliary devices before servicing the equipment. Failure to
properly isolate electrical power to auxiliary equipment before servicing the
equipment can result in personal injury, including death.
Replacing an RTD or Thermostat
You will need the following items:
RTD or thermostat service kit
3‐mm and 5‐mm hex keys
Refer to Section 9, Parts, for service kit part numbers.
To prepare for this procedure
1. Switch off the melter and disconnect and lock out input power to the
melter.
2. Remove the hydraulics cover. Refer to Removing or Installing Covers in
Section 6, Maintenance, as needed.
3. Open the insulation around the hydraulics assembly.
To Next Page
Loading...
