Repair
8-59
Part 1123087_02
3/2014 Nordson Corporation
To replace the hose cuff assembly
See Figure 8‐40.
1. Remove the screws (3) from hose cuff and discard them.
2. Remove the hose cuff (2) by turning it clockwise relative to the hose (6).
3. Install a new O‐ring (1) in the groove near the flange on the hose cuff.
4. Slide the new retaining ring (4) onto the new hose cuff (2).
5. Turn the hose cuff counterclockwise on the transfer hose until it bottoms
out or cannot be turned anymore.
6. Make sure the retaining ring is installed against hose cuff (2) flange, then
install the new self‐tapping screws (3) in the screw holes on hose cuff.
EXPLODED VIEW, HOSE CUFF
1
2
4
3
5
Figure 8‐40 Transfer hose cuff assembly components
1. O‐ring
2. Cuff
3. Self‐tapping screw
4. Retaining ring
5. Hose
To Next Page
Loading...
