Technical Data
10-3
Part 1123087_02
3/2014 Nordson Corporation
Fill Specifications
Parameter Specification
Adhesive forms
Maximum size
Pellets, pastilles, mini‐slats
Pastilles: 12 mm (0.472 in.) diameter
Mini‐slats: 12 mm X 12 mm (0.472 in. X 0.472 in.) in length
Adhesive transfer maximum rate 275 kg (600 lb)/hour (dependent on adhesive type)
Transfer hose length 4 m (13 ft), 9 m (29.5 ft), or 18 m (59 ft)
Operating air Minimum: 4.5 bar (0.45 MPa or 65 psi)
Maximum: 8.6 bar (0.86 MPa or 125 psi)
Total air consumption
17 CFM at 3.4 bar (50 psi) to transfer 105.3 kg/hr (223.2 lb/hr)
with a 4‐m hose at a 4‐m rise
22 CFM at 4.1 bar (60 psi) to transfer 112.5 kg (248 lb/hr) with
a 9‐m hose at a 4‐m rise
30 CFM at 6.2 bar (90 psi) to transfer 90.7 kg/hr (200 lb/hr) with
an 18‐m hose at a 4‐m rise
NOTE: The sequencer ensures that only one melter at a time is
filled with adhesive when multiple melters generate a low level
signal at the same time.
Conditioning Dry, non‐lubricated
Inlet air connection ¼‐in. NPT female
¼‐in. BSPP female
G ¼ female
Pump type Venturi
Adhesive storage bin capacity 120 L (264 lb) or 240 L (528 lb)
Enclosure rating IP54
To Next Page
Loading...
