Nordson PURBlue 4 - Entering the Melter Password

Setup key
Enter key
Operation
4-27
Part 1120277_01
E 2012 Nordson Corporation
Entering the Melter Password
If the melter is password protected, a valid password must be entered before
any setpoint temperature or melter parameter can be changed.
To enter a melter password
1. Press the Setup key.
The left display indicates parameter 0 (flashing) and the right
display indicates 4000.
2. Press the Enter key.
The right display begins flashing.
3. Use the keypad to enter the melter password.
4. Press the Enter key.
One of the following occurs:
S If the password is correct, the left display indicates parameter 1 .
S If the password is incorrect, the left display remains at 0 and the
right display momentarily indicates dashes (----) and then returns to
4000.
If the password is incorrect, re-enter it and then press the Enter key.