Description
2-4
Part 1120277_01
E 2012 Nordson Corporation
Intended Use
PURBlue 4 high-output melters are specifically designed to:
S Melt and pump solid-form hot melt materials in foil wrapped slugs,
such as polyurethane-reactive (PUR), ethylene vinyl acetate
copolymer (EVA), and polyolefine (PO) adhesives, that are
engineered to be liquified and extruded at temperatures at or below
191 _C (375 _F)
S Be used with compatible hot melt hoses and guns that are
manufactured by Nordson Corporation
S Be used in non-explosive environments
Limitations of Use
Use PURBlue 4 high-output melters only for the purpose for which they are
designed. PURBlue 4 melters should not be used:
S to melt or pump any material that creates a health or safety hazard
when heated
S in environments that will require the melter to be cleaned using a
waterwashorspray
Additional Limitations of Use for PUR Adhesives
When the maximum level of harmful substance concentration is exceeded,
use a gas mask and air purifying equipment.
Melter Identification
You will need to know the configuration of your melter when requesting
service or ordering spare parts and optional equipment. Refer to Melter Part
Numbers in Section 7, Parts,ortoMelter Configuration Code in Section 8,
Technical Data, to determine the part number and/or configuration of your
melter.
To Next Page
Loading...
