Installation
3-1
Part 1120277_01
E 2012 Nordson Corporation
Section 3
Installation
WARNING! Allow only personnel with appropriate training and experience to
operate or service the equipment. The use of untrained or inexperienced
personnel to operate or service the equipment can result in injury, including
death, to themselves and others, and damage to the equipment.
Quick-Start
If you have already installed the melter, go to Setting Up the Melter later in
this section for information about how to prepare the melter to operate with
your manufacturing process.
Overview
PURBlue 4 melters are factory-configured for each order and require only the
assembly and set up tasks described in this section.
The melter is shipped from the factory with an installation kit that contains
components that must be assembled on the melter by the customer. Some
additional materials must also be supplied by the customer to complete the
installation.
If optional equipment was ordered with the melter, refer to the documentation
provided with the optional equipment for installation and operating
instructions.
To Next Page
Loading...
