Installation
3-8
Part 1120277_01
E 2012 Nordson Corporation
Unpacking the Melter
Before starting the installation, remove the melter from the pallet, locate the
installation kit, and inspect the melter for damaged and missing parts. Report
any problems to your Nordson representative.
Customer-Supplied Materials
The following additional materials are required to install the melter:
S Four 10-mm machine bolts and locking hardware
S 10 mm
2
(8 AWG) power cable
Contents of the Installation Kit
The installation kit provided with the melter contains the components shown
in Figure 3-2. The quantity and type of hose fittings provided in the kit
depends upon the melter's model number and configuration.
NOTE: Fuses are provided as spares.
The installation kit also contains a package of safety label overlays that are
printed in variety of languages. If required by local regulations, the
appropriate language overlay should be applied over the English version of
the same label. Refer to Safety Labels and Tags in Section 1, Safety,forthe
location of each safety label.
To Next Page
Loading...
