Nordson PURBlue 4 - Page 4

Table of Contents
ii
Part 1120277_01
E 2012 Nordson Corporation
Installation 3-1................................................
Quick-Start 3-1................................................
Overview 3-1..................................................
Installation Tasks 3-2........................................
Experience of Installation Personnel 3-2.........................
Installation Requirements 3-4....................................
Clearances 3-4..............................................
Electrical Power 3-6..........................................
Compressed Air 3-6.........................................
Other Considerations 3-7.....................................
Unpacking the Melter 3-8.......................................
Customer-Supplied Materials 3-8..............................
Contents of the Installation Kit 3-8..............................
Mounting the Melter 3-10.........................................
Configuring the Electrical Service 3-11.............................
Connecting Hoses and Guns 3-16.................................
Connecting a Compressed Air Supply 3-18.........................
Connecting a Pressure Control Signal 3-19.........................
Setting Up the Melter 3-20........................................
Quick Setup 3-20.............................................
Operating Parameters 3-22....................................
Selecting Operating Parameters 3-23..........................
Reading or Editing Operating Parameters 3-24.................
Setpoint Temperature of the Reservoir, Hoses, and Guns 3-28......
Save and Restore Melter Settings 3-30...........................
Review Parameter and Setpoint Temperature Changes 3-32........
Installing Melter Inputs 3-34......................................
Installing Melter Outputs 3-38.....................................
Setting Up Gear-to-Line Operation 3-42............................
Setting Up the Motor Control 3-44.................................
Installing Optional Equipment 3-46................................
Connecting a Gun Driver, Pattern Controller, or Timer 3-46............
Flushing the Melter 3-46.........................................