Location of the mounting holes
Installation
3-10
Part 1120277_01
E 2012 Nordson Corporation
Mounting the Melter
Before mounting the melter, ensure that the parent machine or support
structure is level with respect to the floor, provides an even mounting surface,
is not subject to extreme vibration, and is capable of supporting the weight of
the melter, a full reservoir of hot melt, and the hoses and guns.
Refer to Section 8, Technical Data, for the weight of the melter. Refer to the
technical data provided by the hot melt manufacturer for information about
thevolumetricweightofthehotmelt.
To mount the melter
See Figure 3-3. Use 10-mm machine bolts and locking hardware to secure
the melter mounting brackets to the mounting surface.
ATTACHING BOLT THREAD
ENGAGEMENT MIN 10MM / MAX 30MM
4X M10X1.5 - 6H THRU ALL
382
15.0
1.2
30
1.2
30
12.7
322
10.3
262
14.8
376
27.0
685
FOR MOUNTING FEET
(NOT SHOWN)
4X M6X1.0 - 6H THRU ALL
6.1
155
Figure 3-3 Bolt mounting pattern
To Next Page
Loading...
