Installation
3-33
Part 1120277_01
E 2012 Nordson Corporation
Table 3-7 Change History Log
First Digit
Second
Digit
Third and Fourth Digits
P (Parameter)
-
Indicates the number of the parameter that was changed
S (Setpoint)
Are used in conjunction with the LEDs on the component keys to indicate the
location and method of a setpoint temperature change.
When this LED is
on..
And the Fourth
Digit Indicates..
The change was
to..
And the Method
of Change was..
Reservoir Key 1 The reservoir Individual
Hose Key 1– 6 A single hose Individual
Gun Key 1– 6 Asinglegun Individual
All Keys 0 All components Global
Hose Key 0 All hos es
Global-by-
component
Gun Key 0 All guns
Global-by-
component
Change History Log Examples
Example 1:
Parameter 4 (ready delay) was changed.
Example 2:
If the LED on the gun key is on, then this display would
indicate that the global-by-component method was used to change the
temperature of the guns.
To Next Page
Loading...
