Installation
3-45
Part 1120277_01
E 2012 Nordson Corporation
Table 3-10 Default Motor Control Parameter Settings
Parameter Default Setting Description Explanation
SEt 69 Maximum pump rpm This parameter controls the increment of
change in motor speed that occurs on
each press of the up or down key when
the melter is operating in the manual
mode. To change the rpm in increments
of 1, set this parameter to the maximum
pump rpm.
LoS 0 Minimum pump speed
in gear-to-line mode
If the melter will be operated in the
manual mode, enter 0.
If the melter will operated in the
gear-to-line mode, enter a minimum line
speed. The motor speed will not fall
below this valve even if the signal drops
to 0 V.
dLy 3 Revolutions pump will
turn after reservoir
empty
This parameter controls the number of
revolutions the pump will turn after the
reservoir-empty sensor signals a
reservoir-empty state. After the set
number of turns, the melter will shut
down and display an F9/1 melter fault
code. Refer to Melter Faults in Section 6,
Troubleshooting, for more information on
melter fault codes.
To Next Page
Loading...
