Piston up key
Operation
4-3
Part 1120277_01
E 2012 Nordson Corporation
Loading an Adhesive Slug
ThePURBlue4melterisdesignedtoworkwithPURadhesiveslugsin
sealed foil bags. Before loading an adhesive slug, confirm that the hot melt
material is compatible with the melter. Refer to Intended Use in Section 2,
Description, for information about hot melt materials that should not be used
in PURBlue 4 melters.
WARNING! Hot! Risk of burns! Never use your bare hands. Doing so may
result in personal injury.
WARNING! Risk of personal injury. Closing the lid creates a pinching risk.
Take care when closing the lid.
1. Ensure that
S the hopper empty LED is turned on
S the expiration date of the adhesive slug is not exceeded
S there are no tears or openings in the foil bag
2. Press the Piston up key to raise the piston. The LED illuminates when
the piston is raising.
NOTE: The piston up key is an alternate action switch: when it is
pressed, the piston will start to raise; when it is pressed again, the piston
will stop.
3. See Figure 4-1. When the piston is fully raised, pull up on the handle to
open the lid.
Figure 4-1 Opening the lid
To Next Page
Loading...
