Left display and scroll key
Component temperature display
Setup key
Operation
4-13
Part 1120277_01
E 2012 Nordson Corporation
To manually check a component's temperature
1. Press the key (reservoir, hose, or gun) that represents the component
group you want to check.
The automatic scan stops and the left display indicates the number of the
first sequential component in the selected component group. The right
display indicates the component's actual temperature.
NOTE: When the reservoir key is pressed, the left display does not
indicate a component number (blank display).
NOTE: On PURBlue 4 melters, 1 is the pump temperature and 2 is the
melt plate temperature when the reservoir LED is on.
2. If the first sequential component is not the component you want to check,
use the left-display scroll key to change to the correct component
number.
The right display indicates the actual temperature of the
selected component.
3. Press the Setup key twice to return to the automatic scan mode.
To Next Page
Loading...
