Service LED
Clear/reset key
Operation
4-22
Part 1120277_01
E 2012 Nordson Corporation
Monitor the Service Interval
Themeltercanbesetupsothattheservice LED located on the left side
of the control panel turns on after a customer-defined time period has
elapsed. The service LED may be used to signal the need to change the
hot melt filter or to complete any other customer-specified maintenance
activity. Once the specified maintenance is performed, the service LED must
be reset.
To reset the service LED
With the melter in the scan mode, press the Clear/Reset key to turn off the
service LED and reset the service interval time.
To Next Page
Loading...
