Operating Parameters
B-2
P/N 7135268B
E 2008 Nordson Corporation
PURBlue EC
Standard
0 Enter Password
Description:
A user-defined password that prevents unauthorized changes to setpoint
temperatures and operating parameters.
Value:
0 to 9999
Resolution:
1
Default:
4000
Format:
—
Use:
This parameter only appears if a password is created using parameter 11 and
then enabled using parameter 10.
NOTE: The melter remains in password-protected mode for two minutes after
the last key was pressed. If the user exits Setup mode and then tries to enter
Setup mode again, he must enter the password again, even if two minutes have
not yet elapsed.
1 Total Hours with Heater On (Non-editable)
Description:
Shows the total number of hours that the heaters were on.
Value:
9999 (control panel) and 999.999 on web browser
Resolution:
1 hour
Default:
0
Format:
—
Use:
The display registers up to 9999 hours and then rolls over to 0000.
2 Fault Log (Non-editable)
Description:
Stores a record of the last ten faults.
Value:
—
Resolution:
—
Default:
−F0 (unused log entry)
Format:
F1, F2, F3 and F4
Use:
Press the right display scroll keys to review the last ten faults in the log. Empty
log entries are indicated by ”_ −F0”.
To Next Page
Loading...
