Melter Communication
C-1
P/N 7135268B
E 2008 Nordson Corporation
PURBlue EC
Appendix C
Melter Communication
This appendix describes the installation and use of the Nordson
Configuration Manager (NCM). The following are possible with this
software:
S Installation of melter firmware
S Transmission of operating parameters and setpoint temperatures
between melters
S Saving multiple variations of melter settings.
Software Availability
If you do not have the NCM software yet, you can download it from the
Internet under www.enordson.com/support ProBlue/DuraBlue.
NOTE: When the Configuration Manager is downloaded and installed for
the first time, the newest version of the melter firmware is also downloaded.
If you do not have Internet access, your Nordson representative can send
you the software on a CD.
System Requirements
The following hardware and software requirements must be met to be able
to install and operate the software:
S Serial cable
S PC with:
S CD-RW drive
S COM port
S 640 x 480 color monitor
S Windows 95, 98 (second edition), ME, XP or 2000
S Internet Explorer, version 4.0 or newer (IE 5.0 recommended)
S Administrator rights (Windows XP, 2000 and NT)
To Next Page
Loading...
