Introduction
2-1
P/N 7135268B
E 2008 Nordson Corporation
PURBlue EC
Section 2
Introduction
Intended Use
PURBlue ECt adhesive melters may be used only to melt and convey hot
melt adhesives such as polyurethane (PUR), ethylene vinyl acetate
copolymers (EVA) and polyolefines (PO).
Any other use is considered to be unintended. Nordson will not be liable for
personal injury or property damage resulting from unintended use.
Intended use includes the observance of Nordson safety instructions.
Nordson recommends obtaining detailed information on the materials to be
used.
Area of Use (EMC)
In regard to electromagnetic compatibility (EMC), the melter is intended for
use in industrial applications.
Operating Restrictions
When operated in residential or commercial areas, the melter may cause
interference in other electrical units, e.g. radios.
Unintended Use − Examples −
The melter may not be used under the following conditions:
S In defective condition
S Without protective panels
S With electrical cabinet door open
S With tank lid open
S In a potentially explosive atmosphere
S When the values stated under Technical Data are not complied with.
The melter may not be used to process the following materials:
S Explosive and flammable materials
S Erosive and corrosive materials
S Food products.
To Next Page
Loading...
