Operating side
(= front)
Introduction
2‐3
P/N 213828_11
2014 Nordson Corporation
VersaBlue_PPA
Definition of Terms
Melter Type VA
Standard melter for operating temperatures up to 230 °° C (450 °F ) with
temperature sensors Ni120.
Melter Type VT
High temperature (HT) melter for operating temperatures up to 250 °° C
(480 °F ) with temperature sensors Pt100.
Interface Standard I/O
Component designation: XS2
Transmits the digital input/output signals between the parent machine and
the Nordson melter.
Interface Key-to-line
Component designation: XS5 or XS5.1 and XS5.2 with the option Separate
line speed signal inputs.
NOTE: Key-to-line is also referred to as Automatic mode in Nordson
literature.
In key-to-line the motor/pump speed is proportional to the speed of the
parent machine.
Encoder
The encoder compiles the line speed of the parent machine. It supplies a
certain number of electrical pulses per revolution. The frequency is a
measure of line speed.
CAUTION: The cable length may not be modified; this could cause incorrect
evaluation of the line speed, resulting in incorrect material applications.
Application Head (Gun) = Applicator
In Nordson literature, an Application head is also referred to as Applicator.
Residual Current Device (RCD)
In this manual the term Residual current circuit breaker is used.
To Next Page
Loading...
