4
Changing the Nylon Bar
Use the provided Allan wrench
to remove the five screws, then
hold the nylon bar and carefully
move it out of nylon bar holder.
Warning: Do not put your
fingers against the sharp edge
of the blade at any time.
ransport
Hook the chain to the ring on
the handle and carry the cutter
as shown.
Changing the Blade
Use the provided Allan
wrench to remove the five
screws, then hold the blade
by each end and carefully
move the blade out of blade
holder.
Note: the flat side of the blade
facing the table.
Warning: Do not put your
fingers against the sharp edge
of the blade at any time.
To Next Page