Nortek 2GIG eSeries GC2e - Installation; Control Panel Mounting Plate

D
Mount Holes
Mount Hole
E
G
C
B
GC2e Wireless Security System | Installation and Programming Guide
©2020 Nortek Security & Control LLC. All rights reserved. 13 2GIG is a registered trademark of Nortek Security & Control LLC.
Control Panel Mounting Plate
Mount the Control Panel on the wall in a convenient locaon (or use the oponal desk mount). These tools may be required to mount the Control
Panel onto the wall:
• Screwdriver
• Wire Stripper
• Staple Gun
• Drywall Saw (or equivalent)
• Ladder
1. To remove the oponal desk mount, press the inward on the tabs connecng the base and
panel.
2. Hold rmly, then use your ngernail to detach and remove the panel faceplate (A).
3. Unlock the two capve screws (B) and two latches (C) with a small athead screwdriver to
separate the panel (D) from the boom mounng plate.
4. Depress the two tabs and pull apart to unlock the unit from the mounng plate.
5. Use the level on the mounng plate, then mark the wall for the wiring cutout slot. Use a
drywall saw to cut the slot.
6. If using the oponal LTE (Cellular) Radio Module with an external antenna, remove the plasc
knockout labeled “
” on the mounng plate (E). Mark and cut a slot in the drywall for the
external antenna.
7. Aach the mounng plate to the wall using four (4) screws.
8. Remove the two top screws from the Panel, then replace the screws aaching the Hanger (G).
9. Hang the panel from the mounng plate.
Installation
A Remove Face Plates
B Unlock Locking Screws
C Unlatch Latches
D Remove from Mounting Plate
E
If using external antenna, remove knockout
plate. Use mounting plate as a template
to mark wire cutout hole in dry wall (four
screws).
G Hanger
Figure 5 Control Panel Mounting Procedure
A
Four Tabs
Desk Mount