Nortek 2GIG eSeries GC2e - System Configuration; System Configuration Screens

GC2e Wireless Security System | Installation and Programming Guide
©2020 Nortek Security & Control LLC. All rights reserved. 24 2GIG is a registered trademark of Nortek Security & Control LLC.
NOTE: The other buons let you restore the default Control
Panel sengs and provide access to a variety of system tests.
The System Conguraon screens present installers with
a sequenal list of programming quesons. For a list of all
available programming quesons, see “Programming Queson
Table on page 29.
Figure 28
Q1: Select RF Sensor # (01-48, 63-74).
Figure 27 Installer Toolbox Screen
Aer tapping the System Conguraon buon, the rst
programming queson appears. To learn more, see System
Conguraon Screens.
System Configuration Screens
Use the System Conguraon screens to program sensors into
the system. Installers can access the System Conguraon
screens as described in Accessing the System Conguraon for
System and Sensor Programming.
TIP: To simplify programming, quesons are arranged so that
commonly used values appear early in the queson sequence.
Toolbox and Installer Toolbox