Nortek 2GIG eSeries GC2e - Additional Sensor Types; Additional Sensor Type Descriptions

GC2e Wireless Security System | Installation and Programming Guide
©2020 Nortek Security & Control LLC. All rights reserved. 34 2GIG is a registered trademark of Nortek Security & Control LLC.
Sensor Types (Zones)
Sensor Type (Zone) Descripon
(23) No Response Type
This sensor type is a special zone that can be monitored for activity or inactivity by the Central Station. It does not affect
security system status.
(24) Silent Burglary
This sensor type is for silent triggering the burglary alarm with perimeter doors and windows that will not be used to enter
or exit the protected premises while the system is armed. The Control Panel’s sounder and the bell output will not activate.
An instant silent alarm will occur when this type of sensor is triggered with the system armed in either the Stay or Away
mode.
(32) Remote Device*
This zone type is selected by the installer when pairing the panel with peripheral devices that can ulize localized
troubles (such as RF jam, low baery, tamper, or AC loss detected by the peripheral device). This sensor is connuously
acve and will cause a trouble at the panel for all problem condions. When the panel is in an armed state, this
sensor type will cause an alarm for TAMPER and RF JAM. All trouble condions will be sent to the monitoring staon if
reporng is enabled with the excepon of AC LOSS. This will only be displayed at the panel.
† Indicates Sensor types that are not allowed for hardwired loops.
* Sensor Type Reporng is only supported on Alarm.com.