18
IMPORTANT NOTE
18)
are used when the inducer is rotated to vent
out thru the left or right side of the furnace cabinet.
NOTE:
be installed from inside the cabinet with the threaded
drain line to the threaded end.
Typical Orientation
them together using appropriate primer and cement.
Refer to the typical orientation shown in .
together using appropriate primer and cement.
NOTE:
alignment with other vent pipes.
Alternate Orientation
bond them together using appropriate primer and
cement. Refer to the alternate orientation shown in
.
Permanently bond them together using appropriate
primer and cement.
together using appropriate primer and cement.
NOTE:
alignment with other vent pipes.
IMPORTANT NOTE
2” PVC Tee
1/2” Tubing Formed
into a Loop
(Field Supplied)
PVC
Trap
2” PVC Pipe from Inline
Drain Assembly
(Not Included)
INSTALLATION OF PVC COMPONENTS
(TYPICAL ORIENTATION)
INSTALLATION OF PVC COMPONENTS
(ALTERNATE ORIENTATION)
2” PVC Pipe from Inline
Drain Assembly
(Not Included)
2” PVC Tee
2” PVC Elbow
(Field Supplied)
PVC
Trap
1/2” x 3/4”
Hose Barb
1/2” x 3/4”
Hose Barb
1/2” Tubing Formed
into a Loop
(Field Supplied)
ø 2 1/4” Rubber
Grommet
ø 7/8” Rubber
Grommet
ø 3/4” Rubber
Grommet
Flange
Gasket
FRONT
FRONT lettering must be
located near front
of furnace
Inlet Air
Finish Flange
To Next Page
Loading...
