Nortek GHH12(3.5)LUK4DH - Page 14

10
Introduction for buttons on remote controller
FAN button
SWING button
3
4
Press this button to set fan speed : auto (AUTO), low( ), medium
( ), high( ).
Auto
Note:
Ɣ8QGHU AUTO speed, air conditioner will select proper fan speed automatically
according to default setting.
Ɣ)DQVSHHGXQGHUGU\PRGHLVORZVSHHG
Press this button to select up&down swing angle. Louver angle can be selected
as shown below:
Ɣ:KHQVHOHFWLQJDLUFRQGLWLRQHULVEORZLQJIDQDXWRPDWLFDOO\. Horizontal
louver will automatically swing up&down at maximum angle.
Ɣ:KHQVHOHFWLQJ
ǃ ǃ ǃ ǃ
Ɣ:KHQVHOHFWLQJ
ǃ ǃ
Ɣ+ROGEXWWRQPRUHWKDQVWRVHW\RXUUHTXLUHGVZLQJDQJOH:KHQUHDFKLQJ\RXU
UHTXLUHGDQJOHUHOHDVHWKHEXWWRQ
Note:

ǃ ǃ
PD\QRWEHDYDLODEOH:KHQDLUFRQGLWLRQHUUHFHLYHVWKLVsignal, the
air conditioner will default to automatic setting.
no display
(horizontal louvers stops
at current position)
WHPSHUDWXUH3UHVVF$1EXWWRQWRDGMXVWIDQVSHHG3UHVV6:,1*EXWWRQWR
DGMXVWORXYHUDQJOH&RROLQJRQO\XQLWZRQ¶WUHDFWWRKHDWLQJPRGHVLJQDO
Note:
Ɣ)RUSUHYHQWLQJFROGDLr, after starting up heating mode, indoor unit will delay 1~5
minutes to blow air (actual delay time is depend on indoor ambient temperature).
Ɣ6HWWHPSHUDWXUHUDQJHIURPUHPRWHFRQWUROOHUa
℃(a)）
; Fan speed:
speed, medium speed, high speed.
auto, low
horizontal louver will swing through fixed angles.