ENGLISH 3
USING YOUR OLD FASHIONED MOVIE TIME POPCORN CART™
1. First, find a flat surface near an electrical outlet before starting. (Make sure your cord is
away from any water source. If needed, it is acceptable to use an extension cord.)
Gather your popcorn making supplies; popcorn, seasonings, bowls or bags for holding the
popcorn, cooking oil, measuring cup and spoon. (See parts listed separately with assembly
instructions).
HERE’S A TIP:
Store all of your popcorn supplies in the handy storage compartment in base of unit, then
you will always be prepared and equipped to make hot, fresh theater style popcorn,
anytime!
A B
2. Plug in your unit in the OFF position.
3. Make sure top unit is
properly seated in base unit.
4. Make sure kettle motor
is plugged in.
5. Turn unit ON with switch on crown of machine. Allow
the unit to run for 3 – 5 minutes to heat up kettle.
Turn unit OFF.
6. By using the (1-Tbs.) oil-measuring spoon
supplied with your OLD FASHIONED MOVIE TIME
POPCORN CART™, add 2 Tbs. of your favorite
popcorn cooking oil to the kettle.
7. Then by using the (½ cup) popcorn-measuring cup
supplied, add 1/2 cup popcorn to the kettle.
C
8. Turn the unit ON, close the door. In no time at all, you can hear the popping begin. Then
fresh hot popcorn will begin to burst out of the flip lids on the kettle, just like at the theater!
When popping sounds slow down or stop, turn the unit OFF. Flip the kettle over (see page 4) to
empty the kettle. Repeat steps 6 thru 8 until desired amount of popcorn has been popped.
ENGLISH 4
USING YOUR OLD FASHIONED MOVIE TIME POPCORN CART™ (Continued)
Tip the kettle with the red knob to remove the
last pieces of popcorn, once the popcorn has
stopped popping.
D
D
When removing or replacing the kettle, make
sure it is properly seated in the kettle brackets.
CLEANING
E
Make sure the unit is unplugged before cleaning. Unplug the outer plug to the outlet as well as
the kettle motor plug inside the unit. (See photo item 4 on page 3 for location of motor plug)
2. See instructions on Page 5 for kettle cleaning.
3. Use a slightly damp, non-abrasive sponge or non-abrasive towel to wipe clean the inside
and outside of the unit, then wipe with a non-abrasive dry towel to dry.
NOTE: Never immerse the kettle unit in any liquid – simply wipe clean with a damp cloth.
Never place any parts in dishwasher – always wash by hand.
4. Pull out the kernel catching tray and empty. Wipe out with a damp cloth and dry.
Replace tray.
F
CLEANING THE KETTLE BOWL
1. Switch “OFF” the unit.
2. Pull up the cover and by turning the handle of the bowl anti-clockwise, discard any
unpopped popcorn kernels and oil remaining in the kettle.
3. Wipe out the kettle with a disposable clean cloth. The kettle should be clean but
“Seasoned” and ready for the next use.
To Next Page
Loading...
Need help?
General
