ENGLISH
7
Assembly of Base Support
1. Attach Push Handle (E) from inside Storage Compartment (B) using supplied #1 Screws.
2. Insert Cross Bar (K) into the square inserts on the inside of Base Support (I)
and secure from below with two #2 Screws. Insert the Leg Assembly (L) over
the protruding ends of the Base Support (I) and fasten from the inside of Base
Support (I) using four #4 Bolts, four #5 Flat Washers, and four #6 Nut Caps.
3. Secure Bottom Plate (J) to Base Support (I) using four #2 Screws.
4. Assemble Base Support (I) into the bottom of the Storage
Compartment (B) and secure with four #3 Bolts.
To Next Page
Loading...