What to do if my Nouvag Engine doesn't operate at all?
If your Nouvag Engine isn't working, first ensure the plug is properly inserted and check its fitting. Also, verify that the operating voltage matches what's indicated on the rating plate.
Why is the footswitch not working on my Nouvag TCM Endo III?
If the footswitch isn't functioning, make sure the pedal cable is securely plugged into the rear of the control unit. Also, verify that the control unit is turned on using the main power switch.
How to fix a Nouvag TCM Endo III micromotor that doesn't run?
If the micromotor isn't running, first ensure the motor is turned on using the 'Motor' key or the footswitch. Check that the motor cable is correctly connected to the control unit. Also, make sure the handpiece is firmly pressed onto the motor until it snaps in place.
Microprocessor controlled endodontic motor for root canal preparation with torque control and file protection features.
Details voltage, power, speed range, dimensions, net weight, and fuse requirements for the TCM Endo III unit.
Specifies the recommended relative humidity, temperature, and barometric pressure for safe device operation.
Outlines environmental requirements for transporting and storing the TCM Endo III unit to maintain its integrity.
Explains important symbols on the device, including safety warnings, conformity marks, and disposal icons.
How to start the device, understand the display, and use keypad controls for speed, torque, and direction.
Instructions on using the footswitch to start and stop the micromotor, controlling tool speed and operation.
Functionality of the AL mode to limit torque, preventing file damage, and how to adjust its settings.
How the AP mode prevents file breakage by reversing the motor and its adjustable settings for protection.
Details how the device saves programmed settings like speed and torque, retaining them when powered off.
Procedures for cleaning and disinfecting the control unit and footswitch using approved cleaning agents.
Guidelines for cleaning, disinfecting, and autoclaving the micromotor and its cable to maintain hygiene.
To Next Page
General